Needed a GT2-3mm pulley

Post a reply

Confirmation code
Enter the code exactly as it appears. All letters are case insensitive.
Smilies
:D :) ;) :( :o :shock: :? 8-) :lol: :x :P :oops: :cry: :evil: :twisted: :roll: :!: :?: :idea: :arrow: :| :mrgreen: :geek: :ugeek:
BBCode is OFF
Smilies are ON
Topic review
   

Expand view Topic review: Needed a GT2-3mm pulley

Re: Needed a GT2-3mm pulley

by ArtF » Tue Jan 26, 2016 10:59 pm

Ken:

  Never used the other one, I really printed this one so I could check sizing since I have a belt, but wasnt sure
of the pulleys to match the center distance..but..it feels real good, may have to try it..

Art

Re: Needed a GT2-3mm pulley

by Ken_Shea » Tue Jan 26, 2016 10:27 pm

Art,
Your little 3D printer sure does an excellent job, I had seen where you had printed a pulley some time back, did you end up using it and if you did how did it work out?

Ken

OK, found it, was a T5 pulley.

Needed a GT2-3mm pulley

by ArtF » Tue Jan 26, 2016 1:47 pm

Hi All:

    You know, every once in a while even I get to use Gearotic for what its meant for.
I am looking at powering my ballscrew with a belt, had a GT3mm belt laying around
but no pulleys. So I printed this one to check sizing on the shafts and such..

  I may try using it after all...


Art

Top