Backlash in GT

Post a reply

Confirmation code
Enter the code exactly as it appears. All letters are case insensitive.
Smilies
:D :) ;) :( :o :shock: :? 8-) :lol: :x :P :oops: :cry: :evil: :twisted: :roll: :!: :?: :idea: :arrow: :| :mrgreen: :geek: :ugeek:
BBCode is OFF
Smilies are ON
Topic review
   

Expand view Topic review: Backlash in GT

Re: Backlash in GT

by ArtF » Sat May 21, 2016 4:21 pm

Hi:

We used to do backlash by moving a shaft a small distance away, but that was a poor way to do it, I now recommend you
set the tooth width to .49 or .48 and lower for slop.. except in non-circulars, where tooth width is the tooth of the hob,
so you increase it for slop. :)

Art

Backlash in GT

by SkyMoBot » Sat May 21, 2016 3:07 pm

I thought I asked this years ago or maybe it's covered in one of the videos but I'll ask it again.

GM had a backlash setting when placing gears, I don't think GT does.  What I don't remember is what I am supposed to do if I want a little bit of slop in my gear train.  If there is a video I need to review just point it out.

Top