by ArtF » Tue Sep 16, 2014 11:54 am
Hi:
In the past you added a small correction to the shaft distances, in G2 you make the tooth
a bit thinner by changing the tooth width from .5 ( 50%) to a lower number.. say .48(48%)
and youll find the connection gets looser. This is the way your supposed to do backlash
in gears, the distance bwteen them isnt supposed to change, its always supposed to be
the total of the two pitch radii
Art
Hi:
In the past you added a small correction to the shaft distances, in G2 you make the tooth
a bit thinner by changing the tooth width from .5 ( 50%) to a lower number.. say .48(48%)
and youll find the connection gets looser. This is the way your supposed to do backlash
in gears, the distance bwteen them isnt supposed to change, its always supposed to be
the total of the two pitch radii
Art