GearHeads Forum

Thanks Art..

NOTE for forum archival purpose..

This problem is fixed, should not be seen after next update.

Thx
Art

Hi John:

  Thx, previously noted, fix is in the works for Oct. The sim only is affected, the toolpath , as you suspect, will be fine.
(Well as fine as 4th axis can be for epicycloidals..).

Art

Experimenting with a 0.4 module 10 tooth pinion.

I suspect the cuts are going to be OK but the simulation has them misplaced relative to the image of the finished gear

[img][/img]

see attached screen which also shows tool parameters.

John Prentice