Engraving Florish

Post a reply

Confirmation code
Enter the code exactly as it appears. All letters are case insensitive.
Smilies
:D :) ;) :( :o :shock: :? 8-) :lol: :x :P :oops: :cry: :evil: :twisted: :roll: :!: :?: :idea: :arrow: :| :mrgreen: :geek: :ugeek:
BBCode is OFF
Smilies are ON
Topic review
   

Expand view Topic review: Engraving Florish

Re: Engraving Florish

by Dan Mauch » Mon Mar 06, 2017 9:47 pm

If you email me the dxf file I will use CamBam to convert the line segments to polylines. dmauch@seanet.com Ort at least I will see if Cambam with do it. I have had success with other  files.

Dan Mauch
John T wrote: Hi Art,
Is there any way "workaround" to turn a florish into a single line florish so that It will produce an engraving line.  I can work offsets on the inside to the point that portions are so close they could work as an engraving but at that point they become disjointed and I have multiple fragments instead of a continuous florish line.

John

Re: Engraving Florish

by John T » Mon Mar 06, 2017 12:25 am

Hi Art
Oh good. I can wait - I think! ;D

John

Re: Engraving Florish

by ArtF » Sun Mar 05, 2017 10:02 pm

Hi John:

Not as yet, it is a single line, runs in order from start to end, but I think what you mean is you want a skeleton of
the vine, the single lines that would run in the center? You cannot get that yet, but it is planned..

Art

Engraving Florish

by John T » Sun Mar 05, 2017 4:43 pm

Hi Art,
Is there any way "workaround" to turn a florish into a single line florish so that It will produce an engraving line.  I can work offsets on the inside to the point that portions are so close they could work as an engraving but at that point they become disjointed and I have multiple fragments instead of a continuous florish line.

John

Top