bevel gear placement

Post a reply

Confirmation code
Enter the code exactly as it appears. All letters are case insensitive.
Smilies
:D :) ;) :( :o :shock: :? 8-) :lol: :x :P :oops: :cry: :evil: :twisted: :roll: :!: :?: :idea: :arrow: :| :mrgreen: :geek: :ugeek:
BBCode is OFF
Smilies are ON
Topic review
   

Expand view Topic review: bevel gear placement

Gavin

by Gavin » Sun Feb 03, 2013 5:46 am

I think I get the correct information from shaft posit origin from the project screen so no problem.

Re: bevel gear placement

by ArtF » Sun Feb 03, 2013 2:57 am

Gavin:

  Very true, and on my list for future dev. Since the hole would be elongated
it wasnt initially supplied when I did that section of the engine.

Thx
Art

bevel gear placement

by Gavin » Sun Feb 03, 2013 12:08 am

Hello,
not sure if this a bug report, a feature request or a support question.
when I create bevel gears at 90deg It would be very helpfull to know where to place the shafts.

I see a "gear center" figure but this only applies if the bevel was laid at 0deg.

Gavin.

Top