GearHeads Forum

Thank you very much Art

I always do an 'air cut' to estimate the maximum effektive feedrate achieveable for the job, bacause you explained and recommended this earlier here in the forum.
So this is not causing the effect. Regarding the foil - and if I think about it - you are of course right: it ...

Hello Art

The Eroor 7871 is solved since a longer time. I tried so many things that I do not remember....

I just apendend to this old conversation the new question regarding the speed/laser power corelation.
Yes, the "DistanceCorr" is on. Because I thoght this is one of the 'essences' of Auggie ...

Hello Art, me again...

The above problems where meanwhile all solved (new, faster Computer probably solved it. Fingers crossed).

Somehting else I observed now by chance:
I cutted a thin masking foil. On straigt, faster moves the foil was cut just like it should. Courved, slower sections: no cut ...

Hello Art
After 500mm/min I tried 600, 700, 800, 900, 1000. At 1000 it crashes. Repeatedly. Went back to 900 and it does not crash. Repeatedly.
There is nothing else running, ther is enough CPU and enough Memory.

No clue.....

Best regards
Roman

Hello Art
I left Lookahead at 300 and also everything else as it was.
So the very first thing I did now is run the file at only 500 mm/sec instead of 1000 mm/sec. Works perfect, no fault. The Queue flickers at 299/300/301.

So it must be something speed dependent I assume. Of course I would like to ...

Hello Art
The first thing I did is that I went down to lookahead 100 (normally running at 300). No effect.
Yes, I have backups of everything.
Will now
- Reload Profile from Backup
- Turn off Spindle Lib  (You means SpindleLib-Laser under GCode Scripts? Isn't this essential for Laser usage with ...

Hello Art
More than a year ago we had a long conversation to get Auggie running after an error (http://gearotic.com/ESW/FavIcons/index.php?topic=1980.0).
Since then flawless operation and I did not touch anything. Just used it.
Now suddenly I get an error stop (7871) every time I try to burn. GCode ...

Hello Art

I tested up to 300 and with large files. And Jerk 30'000 and twice the accel rates I normaly have in the Pokeys for Mach3 Milling.
No problems, no faults detected.
Very good, now I do not touch it for a while :-)

Best regards and thanks for all the help.
Roman

PS: A lady from Faronics ...

Hello Art
I installed the 'Freezer' from faronics you proposed....

I test with a frozen system this tomorrow. Thank you.

Roman

Hello Art

It does not seem to be the Memory.

I tried with the biggest G-Code file I have. The maximum RAM Auggie consumes (at least what the Task Manager shows) is 165MB and I have plenty of memory free during the burning.
With this file it crashed all the time.

However, I tried to raise the ...