Brian Law's Clock No. 24 - Gravity Escapement
-
marklazarz
- Posts: 131
- Joined: Tue Dec 01, 2015 1:03 am
Brian Law's Clock No. 24 - Gravity Escapement
As promised on another discussion thread, here is a photo of my Brian Law Clock No. 24. I built this clock because I was fascinated with the gravity escapement, a real pleasure to watch! It runs on 6 lbs. weight and is wound twice daily. It is not a beginner project and really requires an engine lathe to make components according to plan. If I make another one, I would modify the shaft sizes to 1/8" and forget about turning 1/4" shafts to 1/16" at the bearing sites. So far, it's a real good running clock.
You do not have the required permissions to view the files attached to this post.
-
marklazarz
- Posts: 131
- Joined: Tue Dec 01, 2015 1:03 am
Re: Brian Law's Clock No. 24 - Gravity Escapement
No clue why the photo in the previous post was sideways. I hate all the automatic stuff the cameras and viewers do to photos.
Re: Brian Law's Clock No. 24 - Gravity Escapement
Quality Craftsmanship ...
Re: Brian Law's Clock No. 24 - Gravity Escapement
A golden effort !!