Version 2.265 online.

[John T]

Hi Art,
My test was to create a single circular gear, put it on the work bench and then simulate the cut.

If I do it all in metric I can get a simulated cut however I'm still trying to work in imperial measurements and I have changed to inches in global settings, created a 1/16 cutter in the tools and applied an imperial shaft. When I then hit simulation I get the following

Error found, Gearotic: 1907

At that point I'm totally frozen and have to close the program.  I can only guess and I would "guess" that there is a "conflict" between inches and mm, but I can't find where.

John

[ArtF]

Hi John:

  Thx for the test, try version 2.266 and see if it does the same thing.. Im zeroing in and may have to
put another version online with a few more errors as we get closer..

Thx
Art

[John T]

Hi Art,
Downloaded 2.266,  I get the same 1907 error if I try imperial measurements.

John