Re: M3 - M5 - Tool change code and drilling in CAM module
Posted: Fri Dec 05, 2014 11:54 am
Kerry:
That option already exists. If you use the options and select Center as your origin, when you send a gear to the
workbench, it will center the shaft hole on 0,0. This shoudl work for all gears as I always make the shaft center 0,0 on all gears.
Art
That option already exists. If you use the options and select Center as your origin, when you send a gear to the
workbench, it will center the shaft hole on 0,0. This shoudl work for all gears as I always make the shaft center 0,0 on all gears.
Art