GearHeads Forum

That is why when I saw Pokeys was running a special I got a 57CNC on order.

Never seem to have to many controllers hanging around. ;D
I might see if it can run the 3D printer instead of the Ramps board while I wait for the release.
Glenn

Kind of a silly question, but where is this new DL?

Forget it, I found it.

I must be a little slow, or I have missed a post somewhere, but I can't seem to locate the V2.3004 version.
I have downloaded a file off the webpage, but it seems to be v2.3002. Is there another location for the V2.3004 file?

Thanks
John

It's the one that says "Current Development 2.xxx (Click Here) "

Thanks.
I feel stupid now. I guess I downloaded two versions, and had tried to install a previous version.

Just one of those days I guess.

I did the same thing a few days ago, so only feel as stupid as me 

Since you mention sprockets...

Where have the British Standard sizes gone? I seem to remember you added them to the old version of Gearotic. I'm missing the 04B, 06B etc. Any chance you could add them again?

http://www.did-coltd.com/english/produc ... sr_107.pdf

Hi:

  I havent ever removed a sprocket type, but Ill check those and see if I can add them based on this info..

Art