GearHeads Forum

Well, my 57CNC has arrived - now the fun begins  ;D

I am sure I will have lots of questions so I will start a new thread in the Auggie section (once I have found all the necessary connectors, cables, etc. to connect everything up).

Tweakie.

Tweakie:

Welcome to Auggie, then.

    Have fun, you shouldn't find it too bad, youve been at this a long time.
The secret with Auggie to get the Pokeys running your machine using only
the Pokeys standalone configurator first.  You should be able to jog and home etc..

  By selecting peripherals you can change the PWM channel you intend to use and watch
it vary its output as you slide the sliders. When all that occurs, Auggie should run
fine with very little config required.

Yell when confused..

Art