Release Aug 24th 3.05

[n2xd]

I have a noob question. Where do I go to get the latest update? Sorry for such a basic question.


John

[ArtF]

Hi:

On the website www.gearotic.com , use the downloads tab.

There is the files for release version,development and an .msi file
in case of systems that dont like the other installers.

Art

[Campgems]

It the card.  The bug follows the mix of DVI port and Primary monitor, not the monitor, after an afternoon of swapping cables and setups.  Both monitors work OK on the VGA port and either one being primary. Both hang up on the DVI port and being primary.


Sorry for the false alarm.

Don

[ArtF]

Hi All:

  Just a bug note in Auggie. There is a flag that triggers exact stop which is being set on load
of some gcode files. This can cause the system to run only in exact stop mode. Pressing
Rewind after load fixes the problem. I will update the code on next release.

  The problem can be seen to happen if you have a lookahead ( mine is set to 100 for example)
and the queue stubbornly stays at 1. It should show the amount of queued up lines.. This of
course makes a huge difference in speed. Pressing rewind should fix the load and allow
proper CV operation at high speed.

Thx
Art