GearHeads Forum

Art

You mentioned that you created the asset (I assume you used my STL for the bar). If so, perhaps the error is in the creation of the asset. I position the pivot at the top of the bar to (0,0).

When I get a chance I'll try recreating the bar asset with and without repositioning. And then importing the assets.

Bill

Art

My bad. I assumed the truncation was happening during the import of the asset. I had been using the asset that I originally detected the problem.

I just recreated the asset using version 1.12b and the bar is no longer truncated upon import.

Sorry about my misconception of where the problem origninated.

Bill

Bill:

My bad. :) , thanks for confirmation.

Art