Page 17 of 20
Re: getting the 57cnc to work with G540
Posted: Thu Mar 03, 2016 12:05 pm
by ArtF
Thanks Dan:
A great many bugs still exist, but its getting better all the time.
Art
Re: getting the 57cnc to work with G540
Posted: Thu Mar 03, 2016 12:07 pm
by ArtF
I have set the default value of FeedOverRide to 100 for future users so it wont
halt mysteriously on g1's in future.
Art
Re: getting the 57cnc to work with G540
Posted: Thu Mar 03, 2016 6:50 pm
by DanL
ta, it's a new program that works very well, a few bugs don't worry me if I find them I will post about them.
it cuts to the end of the cut it just does not go back to Zero, rewind and turn off spindle. I am going to be finishing the wiring and tiding thing's up.
then I will run some code and vid the not finishing the G code bug
Re: getting the 57cnc to work with G540
Posted: Thu Mar 03, 2016 10:54 pm
by DanL
Re: getting the 57cnc to work with G540
Posted: Fri Mar 04, 2016 2:13 am
by ArtF
Thx Dan:
I think I see the issue.. Nice to see it running on other systems.
Art
Re: getting the 57cnc to work with G540
Posted: Fri Mar 04, 2016 4:07 am
by DanL
I will do a cut vid next week, I still have to do the circuit for 3.3 to 5 that GlennD did. I might machine that out if I can work out how to do that in fusion, I will have to start on the pp for that.
Re: getting the 57cnc to work with G540
Posted: Fri Apr 01, 2016 12:30 pm
by ArtF
Just to close this thread, the G540 is found to work fine with Auggie, any problems turned out
to be software issues with slower computers. The Network Delay option in setup being set to 0
on slow systems fixes this problem, the G540 itself is not and was not an issue. If one wishes
to drive a G540, the easiest way is the USB->DB25 convertor I mentioned today in the
Auggie thread (PoKeys57-DB) which will allow an instant conversion of a G540 Mach3 driven machine
to Auggie and Mach3/4 under USB at 115Khz.
Thx
Art
Re: getting the 57cnc to work with G540
Posted: Sat Apr 02, 2016 11:16 pm
by DanL
yes you are correct art, the G540 is a good to go with Auggie if you let it set its self and read the instructions. do you wont me to do a write up at the end on how it is all connected, I have been doing my Charity work so have not been back at it yet
Re: getting the 57cnc to work with G540
Posted: Sun Apr 03, 2016 1:18 am
by ArtF
Anytime Dan, more info in better than less.
One last note though, we tested a PokeysDB25 this week, and Auggie failed to run it
and crashed, we did find the problem though and next version will run fine.
Thx to YaNvrNo ( db25 serial #7 or so.. lol ), for his db25 testing.
Art
Re: getting the 57cnc to work with G540
Posted: Sun Apr 03, 2016 7:44 pm
by DanL
bugger not number 1 it would worth big $$$ in a 100 years. will do