Page 1 of 1
Auggie Laser Cut Kraken
Posted: Wed Apr 06, 2016 4:23 pm
by ArtF
Found a few bugs in the Image processing in Auggie, after repairs..
This is a Kraken..
12 minutes, 200mm tall on melamine. 10 Watt laser at 80% , 12000 mm/minute
Art
Re: Auggie Laser Cut Kraken
Posted: Wed Apr 06, 2016 4:37 pm
by Joakim
Looks great!
Lots of details
Hope I will get similar results when my K40 is up and running with Auggie and PoKeys57E...
Re: Auggie Laser Cut Kraken
Posted: Wed Apr 06, 2016 5:14 pm
by Ken_Shea
Yes, does look good Art, and at 200ipm, pretty fast too.
I must add.... that's not one of the prettier pictures I seen a laser do ;D
Re: Auggie Laser Cut Kraken
Posted: Wed Apr 06, 2016 6:53 pm
by ArtF
Ken:
Im not why the take such bad photo's but by eye it looks impressive, in photo I guess
its just too magnified. I also was pushing it, that s 12Kmm/min or 472inches per minute..
Laser isnt really powerful enough for that speed, but it tries.
End result is quite nice by eye, looks rough by camera.
Art
Re: Auggie Laser Cut Kraken
Posted: Fri Apr 08, 2016 4:19 pm
by Google Feedfetcher
Is it just me but that reminds me of the Mother-in-Law ?
Re: Auggie Laser Cut Kraken
Posted: Fri Apr 08, 2016 4:20 pm
by ArtF
Probably just reminds you of the tattoo on her chest... :0
Art
Re: Auggie Laser Cut Kraken
Posted: Sat Apr 09, 2016 3:01 am
by Ken_Shea
Art,
Not the quality I was referring to but the content that isn't very pretty.
I've seen John S's Mother in Law and he's right, it does look like her. ;D