Page 1 of 1
Gear placement at a given angle?
Posted: Mon Jul 31, 2017 1:10 pm
by Nic Bwts
Given that the 3 gear in the picture are the same is it possible in Georotic to place the gears with a mirrored symmetry?
Re: Gear placement at a given angle?
Posted: Mon Jul 31, 2017 1:24 pm
by ArtF
Can you better define what you mean by mirrored symmetry? DO you mean tooth meshing on that third one?
Art
Re: Gear placement at a given angle?
Posted: Mon Jul 31, 2017 1:27 pm
by Nic Bwts
Yeah whenever I try to put a second wheel down (the middle gear being the pinion) I get a tooth clash
This example where the gears are at 90 deg to each other
Re: Gear placement at a given angle?
Posted: Mon Jul 31, 2017 1:48 pm
by ArtF
Hmm, that seems like a bug I haven't yet seen. How is it being placed? Left gear, then top right rolled off left, then bottom rolled off of top right?
Ill run some tests..
Art
Re: Gear placement at a given angle?
Posted: Mon Jul 31, 2017 3:22 pm
by Nic Bwts
Top right pinion then topleft rolled off top right then bottom one rolled off top right. Weirldy I cant replicate the error now!
Re: Gear placement at a given angle?
Posted: Mon Jul 31, 2017 3:31 pm
by ArtF
Nic:
Cant seem to here either.. gremlin of some sort perhaps,
Ill keep my eyes open for it. Thx for the bug
Art
Re: Gear placement at a given angle?
Posted: Wed Aug 02, 2017 3:35 pm
by BobL
Tested, works here too. Are you using the latest Gearotic version Nic Bwts?
Re: Gear placement at a given angle?
Posted: Wed Aug 02, 2017 7:15 pm
by Nic Bwts
Yes using the latest version.