Hi Art,
I've noticed that I can't seem to get several gears to output either DXF for .tap files at a single try. I select all the gears I want to output and everything appears OK but when I go the file folder there is only one tap file and I have to repeat the gears individually to get them to Mach 3. Once in Mach 3 they cut perfectly.
John
Multiple Gear Outputs
Multiple Gear Outputs
You do not have the required permissions to view the files attached to this post.
1% inspiration 99% try, try again
Re: Multiple Gear Outputs
Hi John:
Are you pressing the "Copy to all gears" button after selecting dxf or tap? If you select the variosu gears on the output manager screen, the selections change depending on what you stored there. Select several gears and then select output manager, then check DXF and press "Copy to all gears". Does it then put out multiple files?
Thx
Art
Are you pressing the "Copy to all gears" button after selecting dxf or tap? If you select the variosu gears on the output manager screen, the selections change depending on what you stored there. Select several gears and then select output manager, then check DXF and press "Copy to all gears". Does it then put out multiple files?
Thx
Art
Re: Multiple Gear Outputs
Hi Art,
My apologies - all is well. :-\
John
My apologies - all is well. :-\
John
1% inspiration 99% try, try again
Re: Multiple Gear Outputs
John:
, no appologies necessary...thats our mantra
on any questions. .
Art
, no appologies necessary...thats our mantraon any questions. .
Art