Auggie Laser Cut Kraken

Post by **ArtF** » Wed Apr 06, 2016 4:23 pm

Found a few bugs in the Image processing in Auggie, after repairs..

This is a Kraken..

12 minutes, 200mm tall on melamine. 10 Watt laser at 80% , 12000 mm/minute

Art

Joakim · Post by **Joakim** » Wed Apr 06, 2016 4:37 pm

Looks great!
Lots of details

Hope I will get similar results when my K40 is up and running with Auggie and PoKeys57E...

Ken_Shea · Post by **Ken_Shea** » Wed Apr 06, 2016 5:14 pm

Yes, does look good Art, and at 200ipm, pretty fast too.
I must add.... that's not one of the prettier pictures I seen a laser do ;D

Post by **ArtF** » Wed Apr 06, 2016 6:53 pm

Ken:

Im not why the take such bad photo's but by eye it looks impressive, in photo I guess
its just too magnified. I also was pushing it, that s 12Kmm/min or 472inches per minute..
Laser isnt really powerful enough for that speed, but it tries.

End result is quite nice by eye, looks rough by camera.

Art

Post by **Google Feedfetcher** » Fri Apr 08, 2016 4:19 pm

Is it just me but that reminds me of the Mother-in-Law ?

Post by **ArtF** » Fri Apr 08, 2016 4:20 pm

Probably just reminds you of the tattoo on her chest... :0

Art

Ken_Shea · Post by **Ken_Shea** » Sat Apr 09, 2016 3:01 am

Art,
Not the quality I was referring to but the content that isn't very pretty.

I've seen John S's Mother in Law and he's right, it does look like her. ;D

GearHeads Forum

Auggie Laser Cut Kraken

Auggie Laser Cut Kraken

Re: Auggie Laser Cut Kraken

Re: Auggie Laser Cut Kraken

Re: Auggie Laser Cut Kraken

Re: Auggie Laser Cut Kraken

Re: Auggie Laser Cut Kraken

Re: Auggie Laser Cut Kraken