Good morning, I would like to know how to configure the encoder inputs for x, y, z motors. in auggie?
the encoders are 1000 pulses per revolution
many geracias for their response
att. Nestor Delgado
how to configure the encoder inputs for motors x, y, z. in auggie?
-
Vangoth
- Site Admin
- Posts: 8
- Joined: Fri Mar 16, 2018 1:49 pm
how to configure the encoder inputs for motors x, y, z. in auggie?
Last edited by Vangoth on Fri Mar 16, 2018 3:25 pm, edited 1 time in total.
-
ArtF
- Global Moderator
- Posts: 4556
- Joined: Sun Sep 05, 2010 5:14 pm
- Contact:
Re: how to configure the encoder inputs for motors x, y, z. in auggie?
Hi Nestor:
Auggie doesnt use encoders for anything. You can hook them up and write scripts to access
them, just hook them as the PoKeys manual describes, C script commands exist to read them.
I only hook mine to my motor drives.
Art
Auggie doesnt use encoders for anything. You can hook them up and write scripts to access
them, just hook them as the PoKeys manual describes, C script commands exist to read them.
I only hook mine to my motor drives.
Art