Art
You mentioned that you created the asset (I assume you used my STL for the bar). If so, perhaps the error is in the creation of the asset. I position the pivot at the top of the bar to (0,0).
When I get a chance I'll try recreating the bar asset with and without repositioning. And then importing the assets.
Bill
Asset Creation Inserting STLs from Fusion 360
Re: Asset Creation Inserting STLs from Fusion 360
Art
My bad. I assumed the truncation was happening during the import of the asset. I had been using the asset that I originally detected the problem.
I just recreated the asset using version 1.12b and the bar is no longer truncated upon import.
Sorry about my misconception of where the problem origninated.
Bill
My bad. I assumed the truncation was happening during the import of the asset. I had been using the asset that I originally detected the problem.
I just recreated the asset using version 1.12b and the bar is no longer truncated upon import.
Sorry about my misconception of where the problem origninated.
Bill
Re: Asset Creation Inserting STLs from Fusion 360
Bill:
My bad. :) , thanks for confirmation.
Art
My bad. :) , thanks for confirmation.
Art