I've been playing with screws and noticed the minimum teeth is three. Would like to have a single-tooth gear to lengthen(width) in helix form to make single-start screws. see example in video contest entries....
http://www.youtube.com/watch?v=q5aoTOc3Tak
This program is fun to play with..can see the possibilities!
minimum of one(1) tooth for gear.
-
MSN NewsBlogs
- Newbie
- Posts: 26
- Joined: Tue Jan 06, 2026 4:56 pm
minimum of one(1) tooth for gear.
Last edited by MSN NewsBlogs on Tue Sep 28, 2010 12:06 am, edited 1 time in total.